measurements made by the altimeter. Find the altimeter settings under Manage > Sensors >
Altimeter. See Altimeter on page85.
Use GPS - Turns the GPS sensor ON or OFF. Unlike the other sensors, the GPS data is only recorded
during scanning and is thus only available for scan registration in SCENE, if this is switched to ON.
Note that a GPS signal may not be available when scanning indoors. See GPS on page84.
Recommended Settings - Enable all sensors. Remember that the use of the inclinometer will increase the
scan time.
Color Settings
Parameters > Color Settings
There are two option to capture and colorize scans:
l The integrated camera, see section below
l The PanoCam (an additional accessory available from FARO. For more details about PanoCam refer
to the Accessories Manual for the Focus Laser Scanner.)
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 5: Getting Started
FARO Focus Premium (March 2022) Page45of157
To Next Page
Loading...
