Faro Focus Premium - Page 81

Tap, if the project should not have a parent project.
Project Information
Customer
If you are carrying out the scan project for a customer, you can enter the customer's name here.
File Base Name
The scan is saved with a file name consisting of this base name, followed by the current scan number.
Initial Scan No.
This automatically increments with each successive scan. It can be reset and can be used to indicate the
number of scans per scan session. (If a scan with identical scan number and name already exists, the scan
number will be automatically incremented to the next unused number.
Additional Info
Additional project information.
Latitude [°]
Enter the approximate (+/- 10° is sufficient) latitude position of the scan project in decimal degree
notation. This information helps to improve the accuracy of the inclination sensor, and leads to better
scan registration results.
Duplicate a Scan Project
Instead of adding a new, blank project or cluster, you can create new projects by duplicating existing
ones. To do so, select the project to be duplicated, then tap Duplicate at the bottom of the list. The
newly created project has the same settings and properties as the original project.
Delete a Scan Project
Select the project to be deleted in the list and tap Delete. If the project or cluster has subordinates, they
are also deleted.
How Scan Projects Are Saved
Scan projects are stored on the SSD or SD card depending on the settings in storage management.
Projects stored on the SSDcan be exported to the SDcard.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 6: Controller Software
FARO Focus Premium (March 2022) Page74of157