DNS 2 - Second dynamic name server to be used in the WLAN network.
Security - Choose the security protocol to be used by the access point to which the scanner connects:
l Open - Connect to an open network that can be accessed by anyone without a password. The
information exchange is not secured.
l WEP - Connect to a network that is secured by WEP. This option requires an encryption key with 8
to 63 characters. This security level is not secure.
l WPA2 PSK - Connect to a network that is secured by WPA2. This option requires an encryption key
with 8 to 63 characters. This is the default and recommended option.
Encryption Key
The scanner network is encrypted with a WPA2 key. Enter this key on your remote device, when
prompted to establish the connection. If you want to change the encryption key, tap the corresponding
button, then enter your own key. The key must consist of 10 to 63 arbitrary digits.
Proxy Settings
Settings related to connection through a proxy.
l No Proxy - Don't use a proxy. Choose this option, if the network that the scanner connects to has
direct Internet access.
l Manual - Use a manually-configured proxy. Configuration includes:
n Host - The host name (or IP address) of the proxy server.
n Port - The port through which to connect to the proxy server.
n Exclusion List - A comma-separated list of hosts for which no proxy is used.
n User Name - The user name used to log-in to the proxy server (if required).
n Password - The password used to log-in to the proxy server (if required).
Refresh
Tap to refresh the WLAN settings displayed in this screen.
Reset
Tap to reset the WLAN settings to their factory default.
If a connection cannot be established, the status immediately turns off after the message Enabling is
displayed. Check the Network Name and the Encryption Key, when a connection in WLAN mode must
be established.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 6: Controller Software
FARO Focus Premium (March 2022) Page92of157
To Next Page
Loading...
