Farr HD8625 - Page 58

3.16
hD8625 8-
5
/
8
” 35K Tong
Technical Manual
Assembly Procedures (continued...):
34. Re-installsupportrollershaftscontinued:
iii) Installsupportroller shafts(PN101-3939)infourlocationswhere theyarecoincidentalwith thetopandbottombrakeband
lugweldments(topleft&bottomrightweldmentPN=101-0083,topright&bottomleftweldmentPN=101-0096)asshownin
illustration3.H.6.Thesesupportrollersdonotusetoporbottomwashers.
35. Threadthetopshifterbushing(PN101-0020)intothetopplate,overtheshiftershaft,untilsnug.Threadthedetenttube(PN101-
0019)intothetopshifterbushingasshowninillustration3.H.7.Threadthree5/8”NCx5/8”hexsocketsetscrewsintotheremain-
ingthreeportsinthebushing-thesesetscrewsareintendedtobeusedascontaminationbarriersonly.Donotbottomouttheset
screwsontheshiftingshaft,ortheshaftwillnotmove.
IllustratIon 3.H.6: tong assemBly - suPPort rollers (Brake BanD welDments)
MainTenance