2. Commissioning
2-20
Festo Festo P .BE CP FB13-E-EN en 9910c
(Prerequisites: You have copied the symbol file as in step
2 of the preparations).
3. Double click on the symbol of the valve terminal 4.
The mask “Slave properties” appears 5.
4. Select the slave address identical to the selected setting
on the rotary/DIL switch (see chapter 1.2.1) in the slave
and confirm this.
This concludes the station selection.
Configuration with COM PROFIBUS 5.0
Prerequisites:
– Device data base exists in the directory of your pro-
grammer/PC
– The mask “Bus parameter” has been processed (bus pro-
file, baud rate)
– PROFIBUS address has been assigned (see above)
– Station type “FESTO CP FB13” has been selected (see
above)
Configuring Access the mask “Configure”:
1. Click with the right-hand mouse key on the symbol of the
Festo valve terminal. Click on “Configure”in the menu
which now appears.
The mask “Configure” appears (Fig. 2/10).
To Next Page
Loading...
