I&J7000 Series Operating Manual
Section 1: Introduction
Part # 561978B
Rev. H May 04
1. Safety Precautions
1.1 In order to meet the requirements of the European Community (CE) safety
directives, the robot must be placed in an enclosure supplied by I&J Fisnar Inc.
The enclosure will prevent the operator from entering the robot work area and will
generate an emergency stop signal if the enclosure door switch is opened while the
robot is running.
1.2 Make sure the robot and accessories are connected to a properly grounded power
source.
1.3 Do not drop or spill foreign objects or material such as screws or liquid into the robot.
1.4 Do not touch any moving parts while the unit is running.
1.5 Loading and unloading of parts and material must be done when the robot is not
running.
1.6 Changing of fixtures or tooling must be done with the power source disconnected.
1.7 The I&J7000 robot only be operated in an environmental of 0 to 40 degrees centigrade
and humidity of 20 to 95 percent with no condensation.
1.8 Do not store or install the robot in an area where it is exposed to direct sunlight.
1.9 Do not operate the robot where electrical noise is present.
1.10 Only use a neutral detergent for cleaning. Do not use alcohol, benzene or thinner.
To Next Page
Loading...
