FISNAR I&J7300 - Menu 2 Functions

I&J7000 Series Operating Manual
Section 6: Point Type & Function Details
Part # 561978B
Rev. H May 04
- Page 74 -
© 2003 I&J Fisnar Inc.
5. Menu 2
5.1. Numerical Move
Allows the tip to be positioned numerically by entering a number for the X, Y and Z values.
5.2. Save Temp Point
Save Temp Point saves the current XYZ position in a temporary memory area numbered 1
– 9. The save temp point function is also used with the Relocate Data function. See
Section 6: 4.4 Relocate Data.
5.3. Retrieve Temp Point
Retrieve Temp Point retrieves a XYZ position which was stored with Save Temp Point.
5.4. Undo Program
Cancels the last change to the program. Returns to the program state prior to the last
change.
5.5. Redo Program
Re-does the last change to the program which was canceled with Undo.
5.6. Debug Program
Runs the program in Debug mode, using the speed set in Debug Speed starting at the
current point location.