9. Antenna state and power: displays antenna supervisor state (left badge) and the
antenna power supply status (right badge).
a) Antenna states:
i. Initialising – During startup of the GNSS receiver.
ii. OK – Antenna detected and OK, power will be On.
iii. Open – No antenna detected, power will be On.
iv. Short – Antenna short circuit detected, power will be Off.
b) Power states:
i. On – Antenna power supply enabled.
ii. Off – Antenna power supply disabled. Note that after removing the elec-
trical short it can take the GNSS receiver up to one minute to detect this
and return to power On.
Vision-RTK 2 | Fixposition Positioning Sensor 49
To Next Page
