RoHS
The Vision-RTK 2 is in conformity with:
1. Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011
on restricting the use of certain hazardous substances in electrical and electronic
equipment.
2. The Restriction of the Use of Certain Hazardous Substances in Electrical and Elec-
tronic Equipment Regulations 2012 (S.I. 2012/3032).
1.2. FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. Vision-RTK 2 has been tested and found to comply with the radiated and
conducted emission limits for a Class B digital device. The Class B limits are designed
to provide reasonable protection against harmful interference in a residential installation.
The equipment listed generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Re-orient or relocate the Vision-RTK 2.
• Increase the separation between the equipment and the Vision-RTK 2.
• Connect the equipment to an outlet on a circuit different from that to which the
Vision-RTK 2 is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with the limits of a Class B digital device, you must use shielded
interface cables.
The Vision-RTK 2 has been authorized for use in Mobile applications. At least 20 cm (8
in) of separation between the Vision-RTK 2 and the User must be maintained at all times.
Wi-Fi
The Vision-RTK 2 contains a Wi-Fi radio with the following approvals:
• FCC ID: TFB-1004
1.3. Japan
Wi-Fi
Vision-RTK 2 contains a Wi-Fi radio with the following approvals:
Remarks and observations
The following conditions are applicable:
• Antennas for IEEE 802.11a/b/g/n/ac.
• Listed are 2 Dipoles, 1 PIFA, and 1 Chip antenna with a max antenna peak gain of
2.5 dBi at 2.4 GHz and 4.0 dBi at 5.0 GHz.
Vision-RTK 2 | Fixposition Positioning Sensor 2
To Next Page
Loading...