WARNING
Risk of crushing
There is a risk of being crushed by a component that becomes detached because the hoisting
gear and load suspension device are not suitable for handling it.
When lifting, please observe the load distribution information on the packaging.
When the product is in a raised position, transport it slowly and carefully to avoid injury to
persons or damage to the gear unit.
• When transporting the gear unit ensure that it is not damaged.
NOTICE
Damage to the gear unit
When transporting the gear unit, the packing and/or the gear unit paint coating can be
damaged.
When the product is in a raised position, transport it slowly and carefully to avoid damaging the
packing and/or the paint coating.
NOTICE
Damage to the gear unit caused by shock applied to the free shaft ends
The gear unit can be damaged due to shock applied to the free shaft ends.
When the product is in a raised position, transport it slowly and carefully to avoid injury to
persons or damage to the gear unit.
Avoid that the free shaft ends are subject to any shock or load.
Attaching the gear unit
To transport the gear unit, only attach slings to the marked attachment points that are provided
for this purpose.
Please observe the following when attaching slings to the load or raising, lowering or moving it:
• Do not exceed the specied load limits
• If you are using a load suspension device with several load hooks, make sure that the load is
evenly distributed between them
• Note the eccentric centre of gravity
• Make sure that the lifting equipment is securely attached
• Keep your speed down when moving the load
• Do not allow the load to sway and do not attach the load to objects or structures inside the
building
Application planning
4.2 Transport
Assembly and operating instructions A5051en
52 Edition 06/2020
To Next Page
Loading...
