FLENDER B3 A Series - Electrical Connections; Tightening Procedure; Introduction

Further information
You can 󹪝nd additional information on the speed encoder in the speed encoder operating
instructions, provided in the complete gear unit documentation.
5.9.7 Electrical connections
Procedure
DANGER
Electric shock
Live parts can cause electric shock.
Ensure that the entire plant is de-energised before starting electrical installation work.
Carefully observe the 󹪝ve safety rules (Page 15).
To connect the motors and monitoring devices, proceed as follows:
1. Ensure that the connections of the motors and monitoring devices are not damaged.
2. Connect the motors and monitoring devices according to the terminal diagram.
Further information
You can 󹪝nd additional information about the electrical connections in the terminal diagrams
and equipment lists provided in the complete gear unit documentation.
5.10 Tightening procedure
5.10.1 Introduction
Bolts
The bolts must have the following properties:
• Made of steel
• Black-annealed or phosphatised
• Lightly oiled (do not add additional oil)
Assembly
5.10 Tightening procedure
Assembly and operating instructions A5051en
90 Edition 06/2020