FLENDER B3 A Series - Commissioning; Measures Prior to Commissioning; Gear Unit with Backstop

Commissioning
6
6.1 Measures prior to commissioning
Take the following measures before commissioning the gear unit:
• Read and observe the operating instructions.
• Replace the screw plug with the air 󹪝lter or the wet-air 󹪝lter. Read operating instructions BA
7300 for further information.
• Gear units with backstop: Observe the appropriate measures prior to commissioning gear
units equipped with backstop.
• Gear unit with auxiliary drive: Observe the appropriate measures prior to commissioning
gear units equipped with auxiliary drive.
• Fill the gear unit with oil.
• Check the oil level.
• Check the gear unit for leaks.
• Ensure that all pipes and components are 󹪝lled with oil.
Further information
Further information about oil and replacement of air 󹪝lters can be found in the operating
instructions BA 7300 in the complete documentation for the gear unit.
Further information about individual components can be found in the operating instructions for
the components in the complete documentation for the gear unit.
6.1.1 Gear unit with backstop
Take the following measures before commissioning the gear unit with backstop:
• Fill the backstop with oil (Page 105).
• Check that the backstop can be easily rotated in the free-wheeling direction without having
to exert excessive force. When doing his, observe the direction of rotation arrows at the gear
unit.
• Before connecting the motor, identify the phase sequence of the three-phase mains.
Connect the motor corresponding to the de󹪝ned direction of rotation.
Assembly and operating instructions A5051en
Edition 06/2020 95