WARNING
Risk of crushing
There is a risk of being crushed by a component that becomes detached because the hoisting
gear and load suspension device are not suitable for handling it.
When lifting, please observe the load distribution information on the packaging.
When the product is in a raised position, transport it slowly and carefully to avoid injury to
persons or damage to the gear unit.
Attaching the gear unit
To transport the gear unit, only attach slings to the marked attachment points that are provided
for this purpose.
Please observe the following when attaching slings to the load or raising, lowering or moving
it:
● Do not exceed the specified load limits
● If you are using a load suspension device with several load hooks, make sure that the load
is evenly distributed between them
● Note the eccentric centre of gravity
● Make sure that the lifting equipment is securely attached
● Keep your speed down when moving the load
● Do not allow the load to sway and do not attach the load to objects or structures inside the
building
● Loads must not be suspended from the tip of a load hook
● Always place the products down on a level, non-slip and stable base
DANGER
Falling load
There is a risk of fatal injury from falling loads if these have not been securely attached to the
lifting equipment.
Never stand or sit under suspended loads. Do not exceed the load limits of the lifting
equipment.
Packaging
The gear unit is delivered fully assembled. Additional equipment is also delivered separately
packaged, as necessary.
The gear unit may be packed in various forms, depending on the size of the unit and method
of transport.
Application planning
4.2 Transport
REDUREX Gear unit 5200en
46 Operating Instructions 03/2019
To Next Page
Loading...
