5.7.9 Connecting the heating element
Procedure
To connect heating elements to the gear unit, proceed as follows:
1. Check that the heating element connection is not damaged.
2. Install the electrical wiring for the heating elements.
Further information
Further information about the heating can be found in the heating operating instructions in the
complete documentation for the gear unit.
5.7.10 Connecting the bearing monitoring system
Procedure
To connect the Pt 100 resistance thermometer, proceed as follows:
1. Check that the Pt 100 resistance thermometer connection is not damaged.
2. Install the electrical wiring between the Pt 100 resistance thermometer and the evaluation
unit. The customer is responsible for providing the evaluation unit.
Further information
Further information about the Pt 100 resistance thermometer can be found in the Pt 100
resistance thermometer operating instructions in the complete documentation for the gear unit.
5.8 Tightening procedure
5.8.1 Introduction
Bolts
The bolts must have the following properties:
● Made of steel
● Black-annealed or phosphatised
● Lightly oiled (do not add additional oil)
Mounting
5.8 Tightening procedure
REDUREX Gear unit 5200en
Operating Instructions 03/2019 77
To Next Page
Loading...
