Maintenance
8
8.1 General maintenance activities
The operator must ensure compliance with the stipulated time limits. This also applies if the
maintenance activities are included in the operator’s internal maintenance schedules.
The gear unit could be damaged if the stipulated time limits for maintenance and servicing are
not observed.
The time limits stipulated in the maintenance schedule are largely dependent on the conditions
of use of the gear unit. For this reason, it is only possible to state average time limits here. These
refer to the following conditions of use:
● Daily operating time 24 h
● Duty cycle "ED" 100%
● Gear unit input speed 1500 rpm
● Permissible average oil temperature (Page 89)
WARNING
Danger to life due to live system
Working on a gear unit while it is in operation is hazardous and can result in potentially fatal
injuries.
Always shut down the gear unit and any oil supply system (whether separate or mounted on
the gear unit) before you carry out any work. Take measures to prevent the accidental
restarting of the drive assembly. Display a warning notice that clearly states that work is being
carried out on the gear unit.
REDUREX Gear unit 5200en
Operating Instructions 03/2019 91
To Next Page
Loading...
