8.3.8 Checking the auxiliary drive
Further information
You can find information on checking the auxiliary drive in the auxiliary drive operating
instructions, provided in the complete gear unit documentation.
8.3.9 Filling the overrunning clutch of the auxiliary drive with oil
Oil type and filling filter
When filling the overrunning clutch with oil, observe the following points:
● Use the same oil type and oil viscosity as for the gear unit itself.
● Use a filling filter with the same filter mesh size as for the gear unit itself.
Procedure
Proceed as follows to fill the overrunning clutch with oil:
1. Open the oil filling screw of the overrunning clutch.
2. Fill the amount of oil that is specified on the overrunning clutch rating plate.
3. Screw in the oil filling screw.
8.3.10 Checking the cooling coil
Introduction
A soiled cooling coil can cause damage to the gear unit. It is therefore important to check the
cooling coil regularly.
Procedure
To check the cooling coil, proceed as follows:
1. Shut off the cooling water supply.
2. Disconnect the cooling water inlet and drain lines from the cooling coil.
3. Inspect the inner surface of the cooling coil for deposits.
Maintenance
8.3 Maintenance and service work
REDUREX Gear unit 5200en
Operating Instructions 03/2019 97
To Next Page
Loading...
