15 Data logger
FLUXUS WD 15.1 Configuration of the data logger
119
UMFLUXUS_WDV1-3EN, 2018-07-16
Event-based starting time
If it is necessary to start the storing of measured values at
a particular event, select Event-based as starting time.
The event is signalized via an input or the event trigger. All
configured inputs and event triggers are displayed in the
scroll list.
• Select the input or the event trigger through which the
event is to be signalized.
•Press ENTER.
The storage rate indicates the interval how often the mea-
sured values are transmitted or stored.
• Select in the scroll list a storage rate intended to store the measured values in case the event is not triggered.
• Press ENTER.
•Select Off if no measured values are to be stored, as long as the event is not triggered.
• Press ENTER.
• Select in the scroll list a storage rate intended to store the measured values in case the event is triggered.
• Press ENTER.
• Enter the time interval for the measured values to be stored before reaching the event.
• Press ENTER.
• Enter the time interval for the measured values to be stored if the event is no longer active.
• Press ENTER.
Storage rate FastFood
The Storage rate FastF is the storage rate at which the measured values are stored in the FastFood mode.
• Select the menu item Configuration in the program branch Special functions\Data logger.
• Press ENTER until the menu item Storage rate FastF is displayed.
• Enter the value for the Storage rate FastF in ms.
• Press ENTER.
Special functions
Data logger
Configuration
Logger channels
Start storing
Event-based
Storage rate w/o trig.
Storage rate (trig.)
Buffer time
Buffer time
see annex A, p. 162
Special functions\
Data logger\
Configuration
\Start storing\Event-based
Special functions\
Data logger\
Configuration
\Start storing\Event-based\
Storage rate w/o trig.
Special functions\
Data logger\Configuration
\Start storing\Event-based\Storage rate (trig.)
Special functions\
Data logger\Configuration
\Start storing\Event-based\Buffer time ->П
Special functions\
Data logger\Configuration
\Start storing\Event-based\Buffer time П->
Special functions\
Data logger\Configuration
\Storage rate FastF
To Next Page
Loading...
