Flexim FLUXUS WD - Page 157

Annex
FLUXUS WD A Menu structure
157
UMFLUXUS_WDV1-3EN, 2018-07-16
Special settings
(see chapter 13)
Options
Channel x Max. amplification [2]
Special settings Default User-defined Off
Cut-off flow
Pipe signal
detection
[2]
Default User-defined Off
Default User-defined Off
Flow velocity limit [2]
Linear calibration [1]
Default User-defined Off
Default On Off
Enable NoiseTrek
Profile correction [2]
Default User-defined Off
Default On Off
HybridTrek
Multi-point
calibration
[3]
Yes No
Weighting factor
PIG detection [1]
Default On Off
Global settings On Off
Start in meas.
mode
[4]
Turbulence mode
TransitTime FastFood NoiseTrek
Default On Off
Only this mode
Legend
[1] only in ExpertUser, SuperUser and SuperUser ext. mode
[2] from ExpertUser mode
[3] only if enabled in Special functions > Measurement > Measurement settings
[4] only if FastFood is enabled in Special functions > Measurement > Measurement modes
or NoiseTrek mode is supported