Flexim FLUXUS WD - Page 86

9 Measurement
9.2 Measurement settings FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
86
Terminal assignment
The terminals for the connection of the output are displayed.
By pressing key or further information is displayed.
• Press ENTER.
If the transmitter possesses a switchable current output, it is displayed whether it is active or passive.
Output function test
The function of the output can now be tested.
• Connect an external measuring instrument to the terminals of the output.
•Select Yes to test the output. Select No to display the next menu item.
• Press ENTER.
• Enter a test value. It has to be within the output range.
• Press ENTER.
If the external measuring instrument displays the entered value, the output functions correctly.
•Select Repeat to repeat the test, Finish to display the next menu item.
• Press ENTER.
•Select Yes to test the status of the output signal. Select No to display the next menu item.
• Press ENTER.
• Select in the scroll list Passive (idle state) or Active.
• Press ENTER.
If the external measuring instrument displays the entered value, the output functions correctly.
•Select Repeat to repeat the test, Finish to display the next menu item.
• Press ENTER.
• Press key to return to the program branch Options.
9.2.5.4 Switchable current output
• Select the menu item Outputs in the program branch
Special functions.
• Press ENTER.
•Select Active if the current output is to be switched to
active. Select Passive if the current output is to be
switched to passive.
• Press ENTER.
Options\Channel A\Outputs\...\Output info
Options\Channel A\Outputs\...\Test signal
Options\Channel A\Outputs\...\Enter test value
Options\Channel A\Outputs\...\Test mea. range
Options\Channel A\Outputs\...\Enter test value
Special functions
Outputs
Active Passive
see annex A, p. 158
Special functions\Outputs