contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
The parameters on the 2 servers are:
WEB
INTERFACE
PARAMETER <uid>_cong.ini
conguration le
DESCRIPTION
Interface SERVER_Interface
SERVER2_Interface
Choice of the network interface to
be used by the server: Sdcard
If the directories do not exist on the SD card, they will be created automatically by the concentrator.
The SD card information box contains the following information:
• Status: Status of the SD card, the possible states are:
• Unknown: the state is not known because no access to it has been made so far.
• SD Card OK: The last attempt to write to the SD card was successful.
• Failed to mount SD Card: SD card was not detected. Check that the card is correctly
inserted and that it is correctly formatted (FAT32 or exFAT).
• SD Card read error: the SD card was detected but there were errors reading the information
it contains. Check that the card is correctly formatted (FAT32 or exFAT).
• Free space: memory size available on the SD card (in bytes).
• SD card size: capacity of the SD card (in bytes).
• Free space (%): SD card occupation percentage. Allows you to easily and quickly monitor the
lling of the SD card.
At each connection, the hub will deposit data and retrieve information from the SD card. The “SD Card
status” insert reects the information read from the card:
It is of course possible to force a connection by clicking on the “Connect” button present on the page.
To Next Page
Loading...