contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
NTP_Server2 2nd server to query to set the date/time. This
server is used if the 1st server does not respond.
NTP_TimeZone Time zone to apply. This value is used jointly with
the time data returned by the congured NTP
servers. See appendix “Appendix B: Time zone
list” for this list of authorised values.
UTC
SERVER_Address The remote server address to use to connect
to Server 1. This address can be a name if the
DNSs are properly congured or an IP address.
This value is mandatory.
SERVER_Interface Network interface to use to access the remote
server for the Server 1 connection. The possible
values are:
•ethernet: uses the ethernet connection
•modem: uses the 2G/3G/4G interface with the
embedded SIM card
•sdcard : utilise la carte microSD insérée dans
le concentrateur
This parameter cannot be empty
ethernet
SERVER_Type The type of server to which the concentrator is
to connect for the Server 1 connection. There
are several different server types. It is therefore
important to select the right server type.
The possible values are:
•ftp: FTP server
•sftp: SFTP server
•webdav : serveur WebDAV-HTTPS
This parameter cannot be empty
ftp
SERVER2_Address The remote server address to use to connect
to Server 2. This address can be a name if the
DNSs are properly congured or an IP address.
This value is mandatory.
To Next Page
Loading...
Need help?
General