Flexitron Webdyn SunPM User Manual

contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
52
3.1.2.1.3.3 Serial Port Conguration
Serial port conguration is based on the following parameters:
PARAMETER DESCRIPTION DEFAULT VALUE
Type Device type. The possible values are:
•SERIAL1: to congure the “Serial 1” interface
•SERIAL2: to congure the “Serial 2” interface
•SERIAL3: to congure the “Serial 3” interface
SERIAL1 for the 1st line
SERIAL2 for the 2nd line
SERIAL3 for the 3rd line
Baudrate Speed in bauds to use for the serial
connection. The possible values are:
•1200
•2400
•4800
•9600
•19200
•38400
•57600
•115200
•230400
•460800
115200
DataBits Number of data bits per byte. The possible
values are:
•7
•8
8
Parity The parity type to apply to validate data on the
serial link. The possible values are:
•N: no parity
•O: odd parity
•E: even parity
N
StopBits Number of stop bits between 2 bytes. The
possible values are:
•1
•2
1
Wires The number of wires to use on the serial
interface. The possible values are:
•2: the same 2 wires are used to send and
receive data frames
•4: data emission and reception use separate
pairs of wires
2

Flexitron Webdyn SunPM Specifications

General

Brand	Flexitron
Model	Webdyn SunPM
Category	Controller
Language	English