Camera settings
16
◦ Radiometric storage (*.csq): An .csq file supports full radiometry but is only sup-
ported by FLIR Systems software. The file does not include any visual image infor-
mation. With this setting, it is not possible to record video in HSM mode. Also, only
the image mode Thermal is supported when recording video.
Note This setting does not apply to Multi-Rec video files. Multi-Rec video record-
ings are always saved in MPEG (*.mp4) format.
• Video frame rate: Frame rate for video recordings.
• Video microphone: This setting is used to turn on/off the Bluetooth headset
microphone.
• Photo as separate JPEG: A visual image is always saved in the same JPEG file as the
thermal image. Enabling this setting saves an extra low-resolution visual image as a
separate JPEG file.
• Digital camera: Turn on/off the digital camera. Turning off the digital camera can, for
example, be required in restricted areas.
• File naming format: Applies to new image and video files. The setting has no impact
on already saved files.
◦ DCF: DCF (Design rule for Camera File system) is a standard that specifies the
naming method of image files (and much more). With this setting, the name of a
saved image/video file will be FLIRxxxx, where xxxx is an incremental counter. Ex-
ample: FLIR0001. (When the counter has reached 9999, the filename will change
to IR_yyyyy.jpg.)
◦ Date prefix: A prefix will be added to the filename, including the date and the text
“IR_” for images and “MOV_” for videos. The date format will follow the Date & time
format setting, see section 16.6 Device settings.
◦ Date + time only: The filename will only include the date and time.
Note With the Date prefix and Date + time only settings, the files may not automati-
cally be detected by third-party applications.
• Delete all saved files...: This displays a dialog box where you can select to perma-
nently delete all saved files on the memory card.
16.6 Device settings
• Language, time & units: Select the language, units, and date and time formats to be
used in the camera.
• Display settings
◦ Image overlay information: Select what information the camera will display as an
overlay on the image. See also section 5.5 Image overlay.
Note This setting only specifies what information to display on the image. All im-
age information is always saved to the image file and is available in the image
archive.
◦ Screen brightness: Adjust the brightness of the screen. Enable/disable automatic
adjustment.
Note You can also adjust the screen brightness on the Quick menu, see section
5.4 Quick menu.
◦ Viewfinder brightness: Adjust the brightness of the viewfinder.
• Update: Check for updates and install new firmware versions. The camera must be
connected to the internet. See also section 18 Updating the camera.
• Geolocation:
◦ GPS: Enable/disable the GPS.
• Lamp & laser:
◦ Enable lamp & laser: Enable the camera lamps and the laser.
#T810605; r. AD/92464/92464; en-US
79
To Next Page
Loading...
Need help?
General
