ActionStep
Select Function by pressing the joystick left/right. This setting defines what mea-
surement function should be used to trigger the alarm.
4
Select Identity by pressing the joystick left/right to assign an identity to the function
selected above.
5
Select Output by pressing the joystick left/right until Beep is highlighted.6
Specify the Alarm temp by pressing the joystick left/right.
➲ Alarm temp will only be available if Set from ref temp has been disabled below.
7
Specify whether the alarm temperature should be set from the reference tempera-
ture or not by pressing the joystick left/right.
8
Specify Delta alarm by pressing the joystick left/right.
➲ Delta alarm will only be available if Set from ref temp has been enabled above.
9
8
Publ. No. 1557966 Rev. a155 – ENGLISH (EN) – February 6, 2006 49
8 – Tutorials
To Next Page
Loading...
