FLIR ThermaCAM P45

8.6 Changing system settings
8.6.1 Changing the language
ActionStep
Press the joystick to display the horizontal menu bar.1
Point to Local settings on the Setup menu and press the joystick.2
Move the joystick up/down to select Language.3
Move the joystick left/right to change the language.4
Press the joystick to confirm your changes and leave the dialog box.
➲ Changing the language will make the camera restart the camera program. This
will take a few seconds.
5
8.6.2 Changing the temperature unit
ActionStep
Press the joystick to display the horizontal menu bar.1
Point to Local Settings on the Setup menu and press the joystick.2
Move the joystick up/down to select Temp unit.3
Move the joystick left/right to change the temperature unit.4
Press the joystick to confirm your changes and leave the dialog box.5
8.6.3 Changing the date format
ActionStep
Press the joystick to display the horizontal menu bar.1
Point to Local Settings on the Setup menu and press the joystick.2
Move the joystick up/down to select Date format.3
Move the joystick left/right to change the date format.4
Press the joystick to confirm your changes and leave the dialog box.5
8.6.4 Changing the time format
ActionStep
Press the joystick to display the horizontal menu bar.1
Point to Local Settings on the Setup menu and press the joystick.2
Move the joystick up/down to select Time format.3
8
Publ. No. 1557966 Rev. a155 – ENGLISH (EN) – February 6, 2006 51
8 – Tutorials