Limitorque
®
MX Electronic Actuator FCD LMENIM2306-09-AQ – 08/17
99
flowserve.com
“ONLINE” = Device is on-line but has no connections in the established state.
• The device has passed the SELF test, is on-line, bus has no established connections to other nodes.
• For a Group 2 Only device it means that this device is not allocated to a master.
• For a UCMM capable device it means that the device has no established connections.
“CONNECTED” = The device is on-line and has connections in the established state.
• For a Group 2 Only device it means that the device is allocated o a Master.
• For a UCMM capable device it means that the device has one or more established connections.
“CONN TIMEOUT” = One or more I/O Connections are in the Timed-Out state.
“COMM FAULT” = Failed communication device. The device has detected an error that has rendered it incapable of
communicating on the network (Duplicate MAC ID, or Bus-off).
“ID COM FLT REQ” = A specific Communication Faulted device. The device has detected a Network Access error and
is in the Communication Faulted state. The device has subsequently received and accepted an Identify Communication
Faulted Request. Long Protocol message.
LMENIM2306-09 AQ.indd 99 Mittwoch23.08.17 08:53
To Next Page
Loading...
Need help?
General
