Front-Panel Operation
Set Output 4
4-33
14. The Control Display shows your voltage and frequency entries. For example,
123.456 mV and 234.567 mV at 1.1234 kHz (see below).
nn093f.eps
15. Push . The Calibrator erases your entry from the Control Display and copies
it into the Output Display (below is typical).
nn094f.eps
16. Push to activate the Calibrator output.
Two softkey names show on the Control Display: V@NOR/V@AUX and WAVE
MENUS (see below).
gvx095f.eps
• V @ NOR (Voltage at NORMAL Terminals) V @ AUX (Voltage at AUX
Terminals) This is an information-only softkey position and does not have an related
function. It shows the output function is dual ac voltage.
To Next Page
Loading...
