Introduction and Specifications
Safety Information 1
1-5
• Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
• Do not connect directly to mains.
• Do not use an extension cord or adapter plug.
• For safe operation and maintenance of the Product, make
sure that the space around the Product meets minimum
requirements.
This Calibrator complies with:
• ANSI/ISA-61010-1 (82.02.01)
• CAN/CSA C22.2 No. 61010-1-04
• ANSI/UL 61010-1:2004
• EN 61010-1:2001
• ANSI/IEEE Standards 488.1-1987 and 488.2-1987.
Symbols used in this manual and on the Product are in Table 1-1.
Table 1-1. Symbols
Symbol Description Symbol Description
CAT I
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified
by terminal markings.
Conforms to relevant North American
Safety Standards.
Conforms to European Union
directives.
Do not dispose of this product as
unsorted municipal waste. Go to the
Fluke Calibration website for recycling
information.
Risk of Danger. Important
information. See manual.
Hazardous voltage
Earth ground
Conforms to relevant Australian EMC
requirements.
To Next Page
Loading...
