Fluke 5502A - Page 369

C-1
Appendix C
RS-232/IEEE-488 Cables and Connectors
IEEE-488 Connector
The IEEE-488 connector on the rear panel connects with an IEEE-488 standard cable.
The pin assignments of the rear-panel IEEE-488 connector are shown in Figure C-1.
IEEE-488 connection cables are available from Fluke Calibration as shown in Table C-1.
See Chapter 8, “Accessories,” for order information.
Table C-1. IEEE-488 Connection Cables
IEEE-488 Connection Cable Fluke Calibration Part Number
1 m (3.28 feet) Y8021
2 m (6.56 feet) Y8022
NFRD
IFC
ATN
E0I
DIO3
DIO1
SHIELD SRQ NDAC DAV DIO4 DIO2
LOGIC
GND
GND
10
GND
8
GND
6
DIO8 DIO6
GND
11
GND
9
GND
7
REN
DIO7 DIO5
123456789101112
1324 14151617181920212223
fe-01.eps
Figure C-1. IEEE-488 Connector Pinout (connection side)