Fluke 5502A - Page 375

Error Messages
Error Messages
D
D-3
508 (DDE: ) Cannot enter watts by itself
509 (DDE: ) Output exceeds user limits
510 (DDE: ) Duty cycle must be 1.0-99.0
511 (DDE: ) Power factor must be 0.0-1.0
512 (DDE: ) Cannot select that field now
513 (DDE: ) Edit digit out of range
514 (DDE: ) Cannot switch edit field now
515 (DDE: ) Not editing output now
516 (DDE: ) dBm only for single sine ACV
517 (DDE: ) Freq too high for non-sine
518 (DDE: ) Value outside locked range
519 (DDE: ) Must specify an output unit
520 (DDE: ) Cannot do two frequencies at once
521 (DDE: ) Cannot source 3 values at once
522 (DDE: ) Temp must be degrees C or F
523 (DDE: ) Cannot do that now
526 (DDE: ) Limit too small or large
527 (DDE: ) No changes except RESET now
528 (DDE: ) Offset out of range
529 (DDE: ) Cannot edit to or from 0 Hz
530 (DDE: ) Bad state image - not loaded
531 (DDE: ) TC offset limited to +/-500 C
532 (DDE: ) Cannot go to STBY in Meas TC
533 (DDE: ) Cannot set an offset now
534 (DDE: ) Cannot lock this range
535 (DDE: ) Cannot set phase or PF now
536 (DDE: ) Cannot set wave now
537 (DDE: ) Cannot set harmonic now
538 (DDE: ) Cannot change duty cycle now
539 (DDE: ) Cannot change compensation now
540 (DDE:FR ) Current OUTPUT moved to 5725A
541 (DDE: ) TC ref must be valid TC temp
542 (DDE: ) Cannot turn EARTH on now
543 (DDE: D) STA couldn't update OTD
544 (DDE: ) Cannot enter W with non-sine
545 (DDE: ) Cannot edit now
546 (DDE: ) Cannot set trigger to that now
547 (DDE: ) Cannot set output imp. now
548 (DDE:FR ) Compensation is now OFF
549 (DDE: ) Period must be >= 0
550 (DDE: ) A report is already printing
551 (DDE: ) ScopeCal option not installed
552 (DDE: ) Not a ScopeCal function
553 (DDE: ) Cannot set marker shape now
554 (DDE: ) Cannot set video parameter now
555 (DDE: ) Marker location out of range
556 (DDE: ) Pulse width must be 1 - 255
557 (DDE: ) Cannot set range directly now
558 (DDE: ) Not a range for this function
559 (DDE: ) Cannot set TD pulse now
560 (DDE: ) ZERO_MEAS only for C
561 (DDE:FR ) That requires a -SC option