Section
1
Introduction and
Specifications
1-1.
INTRODUCTION
The 6060B Synthesized Signal Generator (referred to as the
Generator
or
instrument)
is
a
fully-programmable,
precision,
synthesized signal generator. The Generator is designed
for
applications that require good modulation, frequency accuracy, and output level
performance with moderate spectral purity. It is well
suited for
testing a wide variety of
RF components and
systems
including filters, amplifiers, mixers, and radios, particularly
on-channel
radio testing.
1-2. UNPACKING THE GENERATOR
This shipping container should
include
a 6060B Signal Generator, an
Operator
Information Card,
a Getting Started Manual, an
Instruction
Manual, and a line power
cord. Any accessories ordered for the
Generator are shipped in a separate
container.
Section
2,
Installation
and Operation, gives instructions on inspecting your new
Generator, and what to do
if the instrument arrives with shipping damage. Reshipment
information is also included.
1-3.
SAFETY
This instruction
manual contains information, warnings, and cautions that
should
be
followed to ensure safe
operation and to maintain the Generator in a safe condition.
The Generator
is
designed primarily for indoor use, and it may be
operated
in
temperatures
from
0°C
to and
50*
C without degradation of its safety.
WARNING
TO
AVOID ELECTRIC SHOCK, USE A POWER
CORD
THAT HAS A THREE-
PRONG PLUG. IP YOU DO NOT
USE
A PROPER POWER CORD, THE
6060B
CASE CAN
DEVELOP
AN ELECTRICAL POTENTIAL ABOVE
EARTH GROUND.
CAUTION
To avoid damage to
the
6060B, check that the rear panel line voltage
selection
card and fuse are correct for the line
voltage
in
your
area. The correct line voltage
and fuse
combinations are:
LINE VOLTAGE FUSE
100/120V
ac, ±10%,
47 Hz to 63 Hz 1.5 AMP
220/240V ac, ±10%,
47 Hz to 63 Hz
.75
AMP
1-1
To Next Page
Loading...