Fluke 6060B - 3-6. Functional Description; 3-7. Level; 3-8. Amplitude Modulation

INSTALLATION
AND
OPERATION
Table
2-8.
IEEE-488 Commands (cont)
UNCAL
lU
none none
Interrogates
the uncalibrated output
error codes. The Generator responds with
three octal fields:
"AAAAA,BBBBB,CCCCC". See Table
2-5
for
a list of uncal error codes.
Software IV none none
Interrogate the software
version. The
Version
Generator responds with the status
message:
"Vxx.x"
where x's are decimal
digits representing
the
current
software
revision level.
HEMORY ENTRY
Recall.
RC int
none Recall
the
front
panel
setup stored
at
the memory location
specified by int.
Store ST
int none Store the current front panel
setup at
the
memory
location specified by int.
Sequence SO none none Sequence (recall)
to
the next
higher memory Location.
MODULATION
ENTRY
Program AM AH float PC Program AM depth
In
percent.
External
AM AE 0/1
none Disable/enable external
AM
modulation.
Internal
AM A1 0/1 none
Disable/enable
internal AM modulation.
Program FH FM float
Program
FH deviation in units
of:
6Z gigahertz
M2
megahertz
KZ kilohertz
HZ
hertz
External
FM FE 0/1 none
Disable/enable
external FM modulation.
Internal FH FI 0/1 none
Disable/enable internal FM
modulation.
Program MR 0/1 none
Program
modulation frequency
Hod Freq to 400 Hz/1000
Hz.
Program
Mod Freq
MF float Program modulation
frequency in
units
of:
62 gigahertz
MZ megahertz
KZ
kilohertz
KZ hertz
MONITOR COMMANDS
Input
Bit
IB
none BIT Respond with
the
value of the
Desig- designated hardware
bit.
nator
Output Bit
OB
0/1 BIT Set
the
designated hardware
Desig- bit to 0
or 1.
nator
2-33