Fluke 6060B - Power-On Conditions

INSTALLATION
AND
OPERATION
message unit. The
record mode off
(“RMO”) is slower
since there
is extra
processing
between
message
units, and the
message
unit is smaller.
If the valid
mode
is enabled, the
processing
of message
units is delayed
until the Generator
has settled
from the previous
message.
If the output
of the Generator
does not need to
be
settled between programming
strings, the
valid
mode should
be turned off to
speed up
processing. If the
output
does not need
to
be settled
between
commands,
but needs to be
settled
between
records, enable the
valid
mode and
the record
mode.
The instrument
processes
commands within the
record as fast
as
possible and wait
for
the output to settle
only
between records.
2-69.
Power-on
Conditions
The
power-on
conditions
of the Generator
depend on whether
or not the IEEE-488
Interface Option
is installed. Table 2-21
lists the instrument
parameters at
power-on with
the IEEE-4S8
Option
installed.
The remote
dear commands
can
be used to reset
all
parameters except
the last memory
location
and the
remote/local
state.
tra
Table
2-21.
IEEE-488
Power-On State
INSTRUMENT
PARAMETER
STATE
notes
Memory
location
parameters
Same as power
off
1
RF on/off
Same as power
off
Last memory
location
Same
as power
off
2
Remote/local
state
Local
IEEE~488
output
buffer
Cleared
lEEE^^SS input
buffer
Cleared
Valid mode
Same as power
off
Record
terminator
Same as power
off
Unbuffered
mode
Same as power off
Record
mode
Same
as
power off
SRa
mask
Same
as power off
Trigger
configuration
Same
as power off
SRQ interface
signal
May be asserted 3
Notes
1-
The contents
of memory location
98 (Instrument Preset State) is
listed in Table
2*'3.
2.
The Last memory
location is used
for
sequence operations.
3.
If
the SRQ mask has the
power on, output
valid,
or ready SRQ enabled.
the SRO
interface
signal is asserted
on
power-on.
2-63/2-64