Fluke 6060B - Page 132

To Next Page

To Previous Page

MAINTENANCE

ACCESS

PROCEDURES

2. Remove the plug-in

capacitor

that couples the Output

board to the VCO,

3. Remove the number 6 screws holding the

assembly,

and remove the board.

4B-3/4B-4

Main Page

Table of Contents2
Title Page3
- List of Tables7
- List of Illustrations9
- 6060B Synthesized Signal Generator10
Introduction11
Safety11
Unpacking the Generator11
Amplitude12
Generator Description12
- Controller Functions12
- Frequency12
Modulation12
Operator Information Card12
Reference12
- Amplitude13
- Modulation13
- Reference13
- Remote-Control Programming13
- Mnemonics14
SIGNAL Generator SPECIFICATIONS15
- Introduction15
  - Installation and Operation22
  - Initial Inspection22
Line Power Requirements22
Setting up the Generator22
IEEE-488 Address23
Rack or Bench Mounting the Generator23
Familiarization24
General Operating Information24
Power-On Sequence24
- Changing Output Parameters24
  - 6060B Outside Dimensions25
  - Front Panel Controls, Indicators and Connectors26
3, Function Entry30
Bright-Digit Edit Operation32
Step Operation32
- Memory33
- Modulation On/Off and Rate33
RF Output On/Off33
Special Function34
- Operating Reference Material34
- Interface Functions59
- Address Mode59
- Going from Remote to Local62
- Talk-Only Mode62
- Listen-Only Mode63
- Command Syntax80
  - Command Processing81
    - Command Execution81
    - Error Handling81
  - Timing Data82
Theory of Operation85
- General Description85
- Front Section85
- Module Section85
- Introduction85
- Rear Section85
  - Functional Description85
  - Functional Description86
- Level86
- Amplitude Modulation86
- Frequency Modulation87
  - Software Operation87
    - User Interface88
    - Amplitude Control88
- Attenuators88
- Modulation On/Off89
- Reverse Power Protector89
  - FM Deviation90
- Self Test90
  - Amplitude Modulation90
- Frequency Modulation90
- Service Special Functions91

Fluke 6060B - Page 132

Table of Contents

Related product manuals