Fluke 8840A User Manual

Operating Instructions
OPEFIATING FEATURES
ERROR
CODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
25
26
27
28
29
30
3 1
32
Table 2-1. Error Codes
MEANING
ANALOG SELF-TEST ERRORS
200 VAC, Zero
700 VAC. Zero
mA AC, Zero
mA DC, Zero
200 VDC, Zero
1000 VDC, Zero
1000 VDC + 20 MS2
20 VDC + 20 MQ
20 VDC + 2000 kQ
2 VDC + 2000 kS2
2008, Overrange
2 kSZ, Overrange
20 kQ, Overrange
200 kR, Overrange
1000 VDC + XI0 T/H + 20 MQ
200 VDC + 200 kS2
200VDC+20ks2
200 VDC + 2 kR
200 VDC, Fitter On
200 VDC + 2 kS2, Filter Off
200 VDC, Filter Off
DIGITAL SELF-TEST ERRORS
In-Guard
@ lnternal RAM
Display
RAM
In-Guard pC Internal Program Memory
External Program Memory
Cali bration Memory
OPERATION ERRORS
AC functions available only with True RMS
AC option.
mA AC or
rnA DC function selected while
REAR inputs selected.
OFFSET selected
with reading unavailable
or overrange.
ERROR
CODE
n
Computed calibration constant out of ran e
(Previous cal may
be wrong or there may
a hardware problem.)
'b.
Calibration input out of acceptable ra*.
Check that input is correct. (Previous cal
may
be wrong or there may be a hardware
problem
.)
Calibration memory write error. (Probab
hardware problem.)
Guard crossing error detected
by In-GArd
PC.
Calibration commqnd not valid unless
Mli-
bration mode is enabled.
Command not valid at this time.
invalid calibration value in Put commaTd.
(Example: Sending a negative value during
ac calibration.)
Command not valid in calibration
verificatidn.
Variable inputs not allowed during AID
dli-
bration. Use prompted value.
Device-dependent commands
not valid dur-
ing self-tests.
Syntax error in device-dependent command
string.
Guard crossing
errpr detected by Out-Gmrd
PC-
Guard crossing error detected at power on
or CAL ENABLE $witch on at power on.
IEEE-488
Interface self-test error.
NOTE:
See the Maintenance section for a detailed description of self-tests.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Fluke 8840A Specifications

General

Frequency Range	20 Hz to 100 kHz
Operating Temperature	0°C to 50°C
Display	Vacuum Fluorescent
DC Current Range	0 to 2 A
AC Current Range	0 to 2 A