Fluke 8840A User Manual

I
Remote Prog mming
EXAMPLE 40GR4MS
lo! This program demonstrates a method of recording any mop produced by the 8840A during self elftat.
20!
30! It should be noted that:
40!
1. If more than one digital test mr occurs, ody the last one wiP be reported.
SO!
2. The response to the Get lnmument ~onfiguradon (GO) command during selftest is "*.
60!
3. The response to a Get Ehror Status (G7) command with no emors present is '1000f.
70!
I
80! FLUKE-BASIC on 1720A, 172241
1 90!
100 DA%=4%
110 TIMEOUT 10000
120 PRINT
!Device address #4
!10 second timeout
130 PRINT "MONITORING SELFTEST"
140 INIT PORT 0 !InitiaI&e port ,
150 CLEAR @DAN !Clear device
160 PRINT @DA%, 20" !Start
170!
180 PRINT @DA%, "G7" \ INPUT @DAN, E$
190 IF (E$ = "1OOO"lTHEN 220
200 PRINT @DA%, %On
210 PRINT "ERROR ";RIGHT(E$,3);" OCCURRED"
220 PRINT @DAN, "GO" \ INPUT @DA%, ST$
230 IF (ST$ >= "9000") GOT0 180
240 PRINT @DA%, "G7" \ INPUT @DAN, E$
250 IF (E$ = "1000") THEN 270
260 PRINT "ERROR ";RIGHT(E$,3);" OCCURRED"
270 PRINT "SELF'IEST COMPLETE"
280 END
!Print analog errors
!Print lqst digital emor
I
I
Figure 3-13. Example Program: Recerd Errdrs During Sel
3-25
~
I
A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Fluke 8840A Specifications

General

Frequency Range	20 Hz to 100 kHz
Operating Temperature	0°C to 50°C
Display	Vacuum Fluorescent
DC Current Range	0 to 2 A
AC Current Range	0 to 2 A