Fluke ScopeMeter 190 II Series - Measuring Resistance Values

4-1
Chapter 4
Performance Verification
Title Page
Introduction ............................................................................................ 4-3
Equipment Requirements for Verification .............................................. 4-4
General Instructions ............................................................................... 4-4
Operation Instructions ............................................................................ 4-4
Reset the Test Tool ........................................................................... 4-4
Menu Navigation ................................................................................ 4-5
Standard Test Tool Setup .................................................................. 4-5
Display and Backlight Test .................................................................... 4-7
Scope Input A, B, C, D Tests ................................................................. 4-8
Input A, B, C, D Vertical Accuracy Test ............................................. 4-8
Input A, B, C, D DC Voltage Accuracy Test ....................................... 4-11
Input A, B, C, D AC Voltage Accuracy Test (LF) ............................... 4-14
Input A, B, C, D AC-Coupled Lower Frequency Test ......................... 4-16
Input A, B, C, D Peak Measurements Test ........................................ 4-17
Input A, B, C, D Frequency Measurement Accuracy Test ................. 4-18
Input A&B / C&D Phase Measurements Test .................................... 4-19
Time Base Test .................................................................................. 4-20
Input A Trigger Sensitivity Test .......................................................... 4-21
Input A AC Voltage Accuracy (HF) and Bandwidth Test .................... 4-23
Input B Trigger Sensitivity Test .......................................................... 4-24
Input B AC Voltage Accuracy (HF) and Bandwidth Test .................... 4-25
Input C Trigger Sensitivity Test .......................................................... 4-26
Input C AC Voltage Accuracy (HF) and Bandwidth Test ................... 4-27
Input D Trigger Sensitivity Test .......................................................... 4-28
Input D AC Voltage Accuracy (HF) and Bandwidth Test ................... 4-30
Video Test with SC600 Scope Calibration Option ............................. 4-31
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com