EasyManuals Logo

Fluke ScopeMeter 190 II Series Service Manual

Fluke ScopeMeter 190 II Series
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Calibration Adjustment
Introduction 5
5-3
Introduction
This section provides the complete Calibration Adjustment procedure for the Test
Tool.
The Test Tool allows closed-case calibration with known reference sources. It
measures the reference signals, calculates the correction factors, and stores the
correction factors in RAM. When the calibration is complete, the correction
factors can be stored in FlashROM.
The Test Tool should be calibrated after repair or if it fails the Performance
Verification. The Test Tool has a normal calibration cycle of one year.
Because the hardware and firmware has changed over the life of the Product,
development of a second version of the adjust procedure has been necessary.
This section has both adjust procedures.
To identify the procedure version you need:
1. Check that the serial number is 25375604 or higher. If yes, use the first
procedure.
2. If no, evaluate the firmware and Subversion. Press in sequence, USER, F3
VERSION & CAL. If the firmware version is V11.00 or lower, use the second
procedure.
If the firmware is V11.10 or higher:
3. In the same popup menu, check under Subversions that the last datablock is
x5xx (for instance 2516). This value determines the higher frequency adjust
point that should be used.
In the tables when red or blue values are listed:
5: The Final Calibration for V11.10 and later procedure should be done.
Use the levels in Red.
2: The Final Calibration for V11.10 and later procedure should be done.
Use the levels in Blue.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Other manuals for Fluke ScopeMeter 190 II Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke ScopeMeter 190 II Series and is the answer not in the manual?

Fluke ScopeMeter 190 II Series Specifications

General IconGeneral
BrandFluke
ModelScopeMeter 190 II Series
CategoryTest Equipment
LanguageEnglish

Related product manuals