Need help?Do you have a question about the Fourier MicroLog and is the answer not in the manual?
Introduces MicroLog as a data logger for temperature and humidity monitoring.
Explains initial setup and connecting MicroLog to a PC for recording.
Covers data displays, minimum/maximum values, status messages, and working modes.
Introduces MicroLog Plus system for wireless monitoring of multiple MicroLogs.
Details system requirements and software installation for MicroLog Plus.
Explains display options in online mode: Meters, graphs, and cradle map.
Describes switching to offline mode, opening saved data files, and printing.
Covers setup, auto setup, saving configurations, and custom sensor definition.
Lists and explains the function of toolbar buttons for MicroLog Plus software.
Describes different cradle models: Alarm Cradle and Wireless Cradle.
Details how to mount MicroLog, connect cables, and operate the cradle.
Provides step-by-step instructions for replacing the cradle's battery.
Explains the function of the cradle's screw terminals for connections.
Guides on connecting the external antenna wires to the receiver.
Explains connecting the external antenna to the cradle's SMA connector.
Details how to configure the cradle's internal jumper for external antenna use.
Specifications for the -50°C to 100°C temperature sensor.
Specifications for the high-precision -10°C to 10°C temperature sensor.
Specifications for the PT100 adapter for temperature measurement.
Specifications for the 0-10V voltage sensor.
Specifications for the 0-20mA current sensor.
Specifications for the pH sensor.
Describes the contact sensor for monitoring switch status.
Details specifications for MicroLog models, inputs, and outputs.
Lists specifications for the MicroLog Cradle, including weight and standards.
Details specifications for the MicroLog Plus Receiver, including range and power.
Outlines MicroLab software features and system requirements.
To Next Page
General