MicroLog Plus Chapter 2
99
2.2.2. Setup the MicroLog Plus System
Before you start using the MicroLog Plus System you must
connect each Cradle to the PC using the serial communication
cable and set it up. Follow the steps below to setup your system:
1. Mount the MicroLogs onto the cradles
2. Open the MicroLab Plus software
3. Connect the first cradle to the PC (see page 162)
4. Set up the first MicroLog data logger (see page 131)
5. Disconnect the first cradle from the PC
6. Repeat steps 3 – 5 with each cradle
Note: When setting up multiple Cradles we recommend to use the
Auto Setup tool (see page 140).
7. Connect the RF receiver to the PC
To Next Page
Loading...