Chapter 1 MicroLog
26
Run – MicroLog is recording data. It will stop recording
automatically when its memory is full (16,000 recordings).
Cyclic Run – Same as Run, but MicroLog will record over the old
data when the memory is full, beginning with the earliest data
recording.
Timer Run – MicroLog can be configured to start recording at a
predetermined time. When MicroLog is set for such a run, its status
is set to Timer Run. Once MicroLog starts recording, its status
changes to either Run or Cyclic Run, depending on the desired
configuration.
1.3.3. MicroLog’s Connections
Note: MicroLog ships with a rubber plug that covers the rear
socket. The plug protects the socket from moisture. Unless you are
using the socket leave the plug in.
To Next Page
Loading...