Fourier MicroLog - Saving Data

Chapter 2 MicroLog Plus
100
8. Click Logger on the menu bar, then click Com setup to
open the Communication setup dialog.
9. Click Try to connect to establish communication with
the receiver.
10. Place the cradles at the desired data logging locations
2.2.3.
Saving data
There is no need to save data manually as the data is saved
automatically every half an hour in the MicroLog Data folder:
C:\Program Files\Fourier Systems\MicroLab Plus\MicroLog Data,
however, you can change the file location.
MicroLab Plus creates a folder for each MicroLog naming it with
the cradles ID number and stores the MicroLog's data in this folder.
MicroLab Plus creates a new data file for each MicroLog every 24
hours at midnight.