Fourier MicroLog - Calibration Password

MicroLog Plus Chapter 2
147
1. Calibration password
To prevent accidental change of the calibration, the calibration
procedure is protected by a password. The default password is:
1234. To change the password:
1. Click Logger on the menu toolbar, then click
Calibration.
2. Click Change Password to open the Change Password
dialog box.
3. Enter the current password in the Current Password
edit box.
4. Enter the new password in the New Password edit box.
5. Enter the new password a second time in the Confirm
New Password edit box to confirm your new password.
6. Click OK.