Chapter 1 MicroLog
70
5. Sensor calibration
A new MicroLog comes fully calibrated. After a period of long
use, however, you may want to recalibrate the humidity or the
temperature sensors.
The humidity calibration affects both MicroLog and MicroLab and
should be carried out while MicroLog is connected to the PC. The
temperature calibration affects only the MicroLab software and can
be carried out regardless of whether MicroLog is connected to the
PC.
Calibration password
To prevent accidental change of the calibration, the calibration
procedure is protected by a password. The default password is:
1234. To change the password:
To Next Page
Loading...