SEP user’s manual Page 10 of 89 Doc no. RD-7243-MA-001-02
2.3. Operational and transport security
When operating the machine, please respect the following safety instructions;
• Respect the equipment’s load capacity.
• Use the machine only in absence of technical defects; be conscious of security measures
and instruction of the user’s manual.
• Immediately correct defects that may affect security.
• Immediately stop the machine if there are changes relative to the security of the machine or
its operative behavior and report the problem to the management of the company or its
representatives.
• Do not modify the machine or add parts that are not included in the official parts list. This also
applies to installation and settings of security devices, for example, the limit switches.
• Do not modify, remove, replace or bypass the security devices.
• Immediately replace damaged, illegible or missing warning notices and signs as well as
security stickers.
∞SEE SECTION 4.10 DATA PLATES AND STICKERS, ON PAGE 31.
• If work is interrupted, turn offf the machine by the main switch and lock with a padlock.
• In situations representing a danger for the operating staff of the machine, turn off the machine
by pressing the EMERGENCY STOP button.
∞ SEE SECTION EMERGENCY STOP BUTTON, ON PAGE 58.
• Lower and stop the machine if winds exceed: > 35 mi/h (> 55 km/h). If winds
exceeding >70 mi/h (> 117 km/h) are expected, secure unit to the ground. If in doubt,
consult effective local regulation and/or your FRACO representative.
• Always protect the machine against unauthorized access and uses!
• Place the load on the platform in a secure manner. Any material that may slide or fall must be
correctly secured
• Do not stand or work under the platform!
• Do not place objects under the platform.
• Distribute load uniformly on the platform and observe maximum load distribution.
• Store materials at a secure distance of at least 20" (50 cm) of any moving part of the
machine.
• The user most ensure that the area where the machine is installed is clean and uncluttered,
as specified in the instructions.
• Any person accompanying the operator must conform to his given instructions. More
particularly, the person must not step over the material being transported in the platform.
• Identify damages, sounds and defects externally recognizable. Immediately signal all
functioning changes or defect to the management of the company or its authorised
representatives and turn offf and secure the machine immediately.
• Important! Adequately illuminate the platform during night shifts and where light is
necessary.
• Inspect the machine before each work shift and at each periodic maintenance inspection.
To Next Page
Loading...