EasyManua.ls Logo

Fraco SEP-5000 - Platform Loading and Unloading; Safety Inspection

Fraco SEP-5000
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transport platform SEP Serie
SEP user’s manual Page 42 of 89 Doc no. RD-7243-MA-001-02
7.5. Platform loading and unloading
• A protection against falls must be provided at loading points of falling height of 10'-0" (3,0 m)
and more (see local regulation) to prevent persons from falling. (Assemble the landing doors
at access levels/floors).
• The platform must always be loaded in a way that loading, unloading and unit control access
is clear.
• The loads must be evenly distributed on the platform.
• Safely position the load. Any material that may slide or fall must be secured.
7.6. Safety inspection
Before beginning work:
• Perform a test operation with a load-free platform.
• Inspect for the presence of obstacles on the trajectory of the platform, on the entire length of
the mast.
• Remove any trace of ice or snow from the end travel switches (winter and cold climate).
The platform will stop immediately if:
• An EMERGENCY STOP BUTTON is pressed.
∞ REFER TO SECTION 7.12 EMERGENCY STOP BUTTON, ON PAGE 58.
• There is an open tailgate.
• The "FINAL" end travel limit switch is activated, at the top or bottom of the mast.
• The platform has reached the end of the mast.
o Inductive detector activated.
o Mechanical detector activated.
• The buffer detectors are activated.
• The emergency safety device is activated.
• There is an open landing door (unlocked).
• The roof access trap is open (optional roof)
The platform will not start if:
• There is an overload (flashing indicator light on the control panel of the platform) (Optional).
• There is an open tailgate and its interlock device is not activated.
• The overspeed detector of the emergency brake is triggered
• The EMERGENCY STOP BUTTON is activated.
• There is an open landing door.
• The roof access trap is open (optional roof)
• The "FINAL" end travel limit switch is activated, at the top or bottom of the mast.
• The platform has reached the end of the mast.
o Inductive detector activated.
o Mechanical detector activated.
• The buffer detectors are activated.
• If a power supply malfunction is detected.
A tailgate cannot be opened if:
• The platform is lowered to ground level or is stationary at an access landing.

Table of Contents