Rev. 5 ā Jun 2020 Page 68 of 91
13 CHANGE LOG
This section contains the list of the firmware updates
that required additions or modifications to the manual.
V. 152
Extended the Store Pattern functionality to the Length
parameter. Now USTA stores all the channels of the pat-
tern, not only the one selected.
Changed the shortcut for the channel Hold function:
hold SET ALL and the desired channel ā CV A, CV B,
Gate A or Gate B. (The previous combination was: hold
ESC and the desired channel.)
Added external PPM (Pulses per Minute) value to the
Dashboard to display how many pulses are received in a
minute by the external clock input (up to 3000).
Added the capability for the Dashboard to display the
currently playing stage in Performance Mode. To acti-
vate it, enter the Project Menu, scroll until the Show-
InPlay option, and select Yes (by default, it is set to No).
When engaged, USTA will use the fourth row of the
Dashboard (which in Edit Pattern mode displays the last
edited stage) to display in real-time all the five stage val-
ues. This option might slow down the device.
Rearranged the Dashboard design to include the total
pattern length (in units).
Added the Mute Channel function: hold ESC and press
te desired channel (CV A, CV B, Gate A or Gate B).
Added CW or CCW pattern rotation while editing it:
hold the track button and rotate the navigation encoder
on the selected pattern. It affects the values of CV A, CV
B, Length, Gate A, Gate B, and the stage colors.
Added the quick initialization of all the track values:
hold the pencil button for 3 seconds in Edit Pattern to
initialize to default all the stage values of the selected
track:
hold the pencil button for 3 seconds in Edit Song to in-
itializes to default all the song slots of the selected track.
Added infinite stage loop:
set the stage loop length to 0 (now accessible):
disable stage loop and continue the pattern by double-
clicking SET ALL.
Added cross-clone layer between CV A & CV B and Gate
A & Gate B: hold the target layer button and press the cor-
responding encoder to apply the clone to a specific pat-
tern
Added a new auxiliary gate target: Run. It uses the in-
coming gate high/gate low signals to start, stop, and reset
USTA with external devices. Four possible configura-
tions are possible, named Run 1, Run 2, Run 3, Run 4.
To activate it, enter the Project Menu, scroll until the Aux
Target option, and select any of the four modes.
V. 150
Added fast change of first/last pattern settings in Per-
formance Mode on the selected track: hold Set All (B.1)
and push an encoder for the first pattern and another for
the last pattern.
Added the cloning of first/last pattern settings, in per-
formance mode, from the selected track to the others, by
double-clicking Shift All (B.2).
Navigating through stages in composition mode up-
dates the stage values on the display across CV A, CV B,
length, Gate A and Gate B.
To Next Page
Loading...