Frap Tools CGM - Specifications; CGM − Creative Mixer; Sapèl

Rev. 5 – Jun 2020 Page 86 of 91
SPECIFICATIONS
1 CGM − CREATIVE MIXER
Parameter
Details
Min
Typ
Max
Unit
Current Draw (0)
Channel
+12V
80
104
mA
-12V
80
100
Group
+12V
80
120
-12V
75
115
Master
+12V
62
101
-12V
44
85
Size
Channel
6
HP
Group
6
Master
6
Audio Input Impedance
Channel
>25
KΩ
Group
Mono
>20
Stereo
>40
Master (2)
>3
CV Input Impedance
Channel
>90
KΩ
Group
>90
Master
>90
Gain scale
Channel direct output (3)
7,5
dB
Send output (3)(4)
4
Group output (3)(5)
12,5
Master outputs (3)
18
Headphones (3)
20
Group output (5)(6)
9
Master aux input (7)
27
Frequency response (8)
0,01
40
KHz
Harmonic Distortion (9)
<0.3
%
(1) Max data obtained with heavy driven output onto low impedance load.
(2) Stereo signal on a single stereo jack.
(3) Without any CV applied and all pot at maximum, gain scale, referred to channel input. Measures subject to ±2 dB tolerance.
(4) With 5V CV patched to main VCA.
(5) Jumpers allowing output of sum of channels and return.
(6) Without any CV applied and all pot at maximum, gain scale, referred to group return inputs. Measures subject to ±2 dB tolerance.
(7) Referred to master outputs. Measures subject to ±2 dB tolerance.
(8) Within 1dB, measured at +10dBu at master output onto a 1KΩ load.
(9) THD+N. On a complete system (Channel to group to master) measured at 1KHz with output signal of +10 dBu onto 1KΩ load with a 10Hz to 80KHz
bandwidth measurement system.
2 SAPÈL
Parameter
Details
Min
Typ
Max
Unit
Current Draw
+12V
250
mA
-12V
170
Size
18
HP
CV input impedance
>90
KΩ
Clock input impedance
on positive pulses
>90
KΩ
clamping negative pulses
~30
Built-in clock frequency (1)
~0.1
60
Hz
Quantized Random Voltage Tol-
erance
<1
%
global offset
-10
10
mV
Clock output
period
~2
ms
amplitude
~9
V
Sampling Glitch
on sample & hold
<400
µs
quantized outputs
n.a.
Colored Noise Output
blue
10
dBU
RMS
white
10
pink
7
red
4
global tolerance
-2
2
dB
(1) Lower frequencies may be achieved (longer times) with a negative CV used as modulation.