118
Parameterisation of the ow meter
1. Press the S button for 2 seconds.
► The operator panel switches into the Function
selection mode.
1. Initial situation: The screen for setting the reversed
output is displayed, the lower line ashes.
2. Press one of the ARROW buttons, until the upper line
shows F1.
3. Press the S button, to enter the lower line.
6. The screen for setting the reversed output appears
on the display.
Continue parameterisation with the next section “Se-
lection of reversed output”.
4. Choose HYS with the ARROW buttons.
5. Press the S button, to conrm the choosen setting.
Basic setting
Selection of
output mode
Selection of
reversed output
The basic setting of the control unit is the measurement mode. In this mode, the ow is
detected and the switching function is in operation.
IMPORTANT! If no button is pressed for 30 seconds during the change of a setting,
the display will start ashing. This is to prevent from incomplete settings, in case of the
operator should leave the machine during setting process.
The following settings are available:
HYS Hysteresis mode
WIN Window comparator mode
ACCUMU Accumulated output mode
PLS Accumulated pulse output mode
The following settings are available:
I_P Normaler output
I_N Reversed output
2. Choose I_N (reversed output) with the ARROW buttons.
3. Press the S button, to conrm the choosen setting.
4. The screen for entering the set values is shown on
the display.
Continue parameterisation with the next section “In-
put of set values”.
To Next Page
Loading...
