EasyManua.ls Logo

Fronius CU 1800 - Disassembly and Disposal; Personnel; Disassembling the System; Disposal of Components

Fronius CU 1800
146 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
132
The device contains uorocarbon (HFC) as a refrigerant, as well as compressor oil.
When disposing of the refrigerant and the compressor oil, the regulations and standards
applicable in the country concerned must be observed.
The discharge of refrigerant into the atmosphere is prohibited by law. The refrigerant
must be recovered and properly disposed of by means of specic equipment.
Do not mix the compressor oil with household waste. Waste disposal must also be car-
ried out by means of specic facilities intended for this purpose.
Disassembly and disposal
Disassembling
the system
The system must only be disassembled and disposed by appropriately-qualied
technicians!
Personnel
Electrical equipment:
Disposal of
components
DANGER!
Risk of fatal injury from dangerous electrical voltage.
The areas bearing this symbol contain parts that are under dangerous electrical volt-
ages. Electrically-charged parts (capacitors)
can remained charged for a considerable length of time after they are switched o󰀨, An
electric shock can be fatal!
Before opening control cabinets or machines:
- Move the mains switch to the O position
- Switch o󰀨 all supply leads and unplug them from the mains
WARNING!
Danger of environmental damage
Incorrect disassembly and disposal of the separate system componnets can result in
serious environmental damage.
- The separate system components must only be disposed of by appropriately-quali-
ed technicians.
NOTE!
If you have any further questions about disposal / recycling please address them to the
manufacturer.

Table of Contents

Related product manuals